Side & roof panels are manufactured from 0.6mm cold rolled corrugated galvanised steel & for additional strength the unit has a structural frame which is fitted at each end & at the centre of the unit
The sump is manufactured from 2mm structural grade galvanised steel & is fitted with base plinths to keep the underside of the units out of contact with the ground
The double doors, fitted with 3 upper & 3 lower vents in each door, are located on one of the short sides of the unit & are secured with a Kale mortis lock with cylinder (152R)
Complete with two sets of shelves (60kg shelf U.D.L.) on each of the long sides of the unit
Base is manufactured from 3mm mild steel with RHS cross members & pressed ribs
Corner posts, shelf frames & main rails are rolled hollow section
The roof is pressed with suitable bracing & fully welded around the perimeter, while the back, side & door panels are pressed from 2mm mild steel sheet & corrugated where required
Fitted with crane lifting points (maximum 2000kg per lift point) & sliding doors
The floor area above the sump is covered with galvanised steel channel sections so that loose drums or pallets can be stored directly onto it, whilst the upper shelf is an open box section which is designed to support pallets. Grid mesh shelving is available - please call for details
Shot blasted before being painted (RAL 6029) for greater durability
Other colours are available - please call for details
EDRIB9624 - push back system above the sump, allowing the units to be pushed to the back of the units